NAZA-M Assistant Software Error Code List

CFG-ERR

Configuration error, this may cause by firmware upgrade from old version. or abnormal Tx calibration. Re-calibrate your transmitter, and power cycle your controller and check all of the parameters.

VOL-LOW [4]

Voltage low

SN-ERR

Your S/N is not available, Please contact our support!

VOL-LOW[6]

Voltage low

IMU-ERR

IMU ERROR,Please contact dealer or DJI for repair.

X1-ERR

You’ve chose parameters tuning by X1/X2 channel with Tx Knob, but no signal detected on X1/X2 input channel, or Tx didn’t powered on.

X2-ERR

You’ve chose parameters tuning by X1/X2 channel with Tx Knob, but no signal detected on X1/X2 input channel, or Tx didn’t powered on.

PMU-ERR

Please check the connection among battery, MC and PMU.

RX-ERR

Please may sure you select the right receiver type in the RC page or check the receiver connection, after that power cycle your controller to take effect.

COMPASS-ERR

Compass data is abnormal, please restart your Controller, if you still get this error, please contact the agent.

ERROR [25]

IMU initialization failure, may caused by crash. Please contact dealer or DJI for repair.

ERROR [26]

Please perform Advanced Calibration.

ERROR [27]

GPS not calibrated, or magnetic field interference. Please calibrate GPS again in good condition.